Schaller BM 4L BC

55

Set of tuning pegs for 4-string electric bass

  • Design: 4 pegs, left-hand
  • Vintage style
  • Gear ratio: 1:20
  • Schaller No: 10250401
  • Finish: Black Chrome
Available since December 2008
Item number 221600
Sales Unit 1 piece(s)
Colour Black
$79
The shipping costs are calculated on the checkout page.
In stock
In stock

This product is in stock and can be shipped immediately.

Standard Delivery Times
1

55 Customer ratings

4.9 / 5

You have to be logged in to rate products.

Note: To prevent ratings from being based on hearsay, smattering or surreptitious advertising we only allow ratings from real users on our website, who have bought the equipment from us.

After logging in you will also find all items you can rate under rate products in the customer centre.

quality

31 Reviews

t
Precise and stable
taddeomaiden 21.10.2017
The machine heads are extremely solid and allow precise tuning and stability.
Esthetically flawless and elegant as any black hardware, the installation is easy, IF you have corresponding holes, otherwise you might have some difficulties, as I had, because the mounting rings are slightly smaller than the most common ones.
The machine heads are similar to the newest ones used on Fender basses, although they don't have the typical trapezoidal plate but a smaller one.
quality
1
0
Report

Report

r
great quality
remork 30.11.2020
used for experimental long string instrument, to put tension on +2m piano wire. did the job just fine. had to (over)tighten the screw because of higher tension than usual (and unorthodox break angle), which put too much tension on the plastic washer inside, but once installed properly they held out without further complaints. that said, if you're using them for what they were are for, instead of the abuse i put them through, i'm sure they will also satisfy :)
quality
0
0
Report

Report

P
All good
Plywoo 19.11.2021
I used these to replace the revoltingly bad tuners on my Sterling Ray 35, and they are pretty much flawless so far. For info, I had to drill new holes on the bass head but that's unavoidable, at least for black tuners.

I haven't seen any issue with these, they seem solid, keep the tune perfectly and are easy to adjust. Simple and flawless as a good hammer.
quality
0
0
Report

Report

up
Schaller nuff said.
unknown pleasure 19.11.2019
Got these on my Ray 24 as well in chrome. Got these for the PB-20 bass.
They're black chrome. Feels like powder coat way more durable then any paint.
Never had issues with schaller products and I have been using them since the 80's.
Everything is there, screws, rims the lot. I put a dab of grease on the worm for extra smoothness.
Excellent replacement for any type of P/J bass or stingray.
You can reverse these so for a Ray look no further.
quality
0
0
Report

Report