Harley Benton Boss bottom plate w/Hook

Contrary to the official Boss' plate, this one actually works with newer pedals due to a cut-out, on the front, for a power plug block. Velcro is not the strongest, but a full plate of it does the trick. Overall - a solid product!

fits perfectly on my boss pedal, and the velcro is nice.
I have only one boss pedal on my board and I didn't want to ruin the original bottom plate by sticking velcro on it. This one was a cheap and perfect option. Simple and efficient. I might buy this again when I buy another boss pedal.

The product is suppossed to offer a way to keep your Boss pedals in original state. When trying to mount one I noticed it just doesn't work due to the lack of a recessed area in the corners, to adapt for the the rubber baseplate on Boss pedals, making it not perfectly flat. If it would have been perfectly flat one would just mount velcro directly. Don't buy. You will get frustrated and might damage the screwholes of your pedal.

If you like to velcro your pedals but don't want to flip the original boss plate around, or tear off the rubber, these are a great alternative.

I'm going to keep this short: a decent product, does the job 100% - buy with confidence. They *can* be a little tricky to remove - but that's nothing to do with the product as such, it is just the nature of removing a well-fitted metal plate, from a metal Pedal casing. I found removing the screws on the pedal, and putting the pedal back on the corresponding Velcro, helped remove the plate very easily. It's a total NON-issue, if you keep the above tip in mind. I recommend.

I've used these on a couple of Boss pedals, and it was exactly what i needed.

They fit quite well, but the screws stick out, might stick out further than your board tape

Perfect fit for DD5 delay would highly recommend and buy again