JJ
Too tall for flat tops
This product is a bit too tall for normal flat top guitars, like my custom Explorer, the pickup has to be flush to the pickup frame so it doesn't touch the strings.
I replaced it after a few months.
The neck frame is perfect.
I replaced it after a few months.
The neck frame is perfect.
1
0
Report
V
Great!
Was looking for this weird spacing and here I found it. I think the Goldo frame is exactly the same product (from the same factory in Korea) but twice the price so what's not to like about this HB frame!
1
0
Report
TG
These are slightly narrower than most common rings, which was exactly what I was looking for. I replaced the originals of my early 2000's LTD Viper and they were identical, same manufacturers part number stamped on the inside. All the spares I had were slightly wider which would have caused issues lining up the screws with the existing holes.
0
0
Report
d
Fits Epiphone Les Paul Slash AFD Special II perfctly
Had no issues fitting this to my Les Paul.
0
0
Report
Ra
If it fits...
... can't wrong with something that either fits or doesn't. There is certainly no sonic differences between this affordable pick-up ring and a more expensive one. The humbucker size is standard. and if the screws that holds it are slightly off, the new holes would be invisible. Recommended.
0
0
Report
A
Harley Benton Hu Frame
This works as should and fit normal holes. Remember - if your guitar currently has two same size rings you will need to order longer screws to fit this!! One other note - this is tapered on the bottom so one end sits higher than the other!
0
0
Report
T
does what it supposed to
As good as any other Frames I have bought so far.
I cannot see any difference to more expensive frames I have bought in the past.
I cannot see any difference to more expensive frames I have bought in the past.
0
0
Report
D
Quality mount ring
My ring was taller than the one I replaced. I may have ordered the wrong part. I kept it for a backup ring mount as it is nice quality.
0
0
Report
im
overall great
I don't think that the quality could get any better, anyway you look it , it's just a pickup frame.
The demensions are mentioned BUT its pretty high and perhaps the strings could colid with it. I'd suggest you just buy 2 frames for the neck and they should do fine!
The demensions are mentioned BUT its pretty high and perhaps the strings could colid with it. I'd suggest you just buy 2 frames for the neck and they should do fine!
0
0
Report
r
Perfect
Spent ages trying to find pickup rings that would fit my ESP LTD MH400NT and came across these. Perfect fit, lines up with the holes on the body and are basically the same size as the original ESP ones I had to replace.
0
0
Report