MC
Simple and solid build
Got this for the inputs for my pedalboard.
Solid construction its built like a tank, works as expected and a pleasure to have on my precious pedalboard.
Solid construction its built like a tank, works as expected and a pleasure to have on my precious pedalboard.
4
0
Report
KM
A great basic patch-bay for pedal routings
If you want your pedals stacked and tidy and your signal crystal clear, the 4M is a great solution for your routing needs.
The quality and build of the unit is outstanding. The passive design means it preserves your signal´s purity at any routing diagram.
Indispensable for complex pedal setups in the studio or live performance.
The quality and build of the unit is outstanding. The passive design means it preserves your signal´s purity at any routing diagram.
Indispensable for complex pedal setups in the studio or live performance.
0
0
Report
LS
Making life easier and difficult at the same time
I love the idea of this bay. I can have pedals, like my volume pedal on the floor. But soon after putting it to use I noticed a volume drop of which I suspected my new phase 95 first. After realizing that there was a crackling sound coming from the patch bay I decided to take it apart. I have an electronic degree, it’s not expensive and since there are absolutely no active components inside it felt quite safe to do so. So, before someone decides to buy this I would like to share that what I found inside should not be put on the market as is. The upper jacket are mounted on circuit boards that sit 90 degrees in a slit of the “mother board “ . To make this 90 degree angle only a drop of, brittle in nature, tin solder is applied. To fix this issue I have bended 90 degree wires, left over snaps from carbon resistors, and soldered those in place. Now I will put epoxy paste on the back side for a solid fix. Why did I not send it back? Because I had a solid idea of what to expect and it’s an easier fix for me than having to buy the components and make my own patch bay
0
0
Report
a
Great companion for busy pedalboars
This is an amazing little unit that is built like a tank and perfectly does its job. I use this so I can manually change the configuration of my pedal board and also to have a single place where to plug things.
It does this perfectly.
It does this perfectly.
0
0
Report
S
Perfect
This is a good solution for troublesome pedalboards, like flight case boards, where you need to angle the boards input/output away from hitting the outer rim of the case.
0
0
Report