Rockboard Z-Connector nickel

I had this on my board between two Mad Professor pedals to save space on the board, and it worked fine for a while. After that I started getting scratchy noises when hitting the two pedals that were joint by this. I replaced it with a cable, and the noise went away. My guess is that the pedals moved sligtly on the pedal board, so they were not perfectly aligned anymore. But if you could align the pedals and make sure they moved as much as a mm, then it would probably work fine.

the jacks in/out from the pedals are often not aligned when they rest on a flat surface. so beware!

These connectors from Rockboard are really nice. They are small and strong. I really recomend if you are searching for something clean and small.
Pay attention with your power supply connection because for some pedals it just doenst fit.

It works fine to level the pedals. No difference in sound.

These connectors are strong, well made and take up very space, ideal for a crowded pedal board. The offset design allows pedals of different makes to be connected, for example I connected a Boss pedal to an Ibanez. I also used Rockboard N and S connectors with similar results.

This connector is just perfect for fit your pedals.
Very useful when you need to save space between pedals.
Its not the cheapest one but it works great!

The ideia of those conector is really good, but it is bad for the jacks of your pedals. The best way possible to connect them is by patch cables.
It is just a bad ideia to connect to jacks with no flexibility between them.

Perfect for builds that have no spare space.

Best used in applications where the pedals won't get pressed much, like in a rack as I'm not sure it won't damage the connectors over time if you are stomping hard on pedals