5
Easy to install and works as it should.
However, I didn’t check the dimensions of this pot, and had to extend mounting hole in the guitar. And you might want to be careful soldering ground wire to the pot. While soldering, I might have damaged the pot and now it can be turned in never ending circle (it still works though)
However, I didn’t check the dimensions of this pot, and had to extend mounting hole in the guitar. And you might want to be careful soldering ground wire to the pot. While soldering, I might have damaged the pot and now it can be turned in never ending circle (it still works though)
0
0
Report
j
Smooth, fast and reliable.
If you are looking for smooth and fast operation, firm switching, no noise and no loose signal, DiMarzio pots will please you beyond expectations.
I used two on my guitar, a master vol with phase shifting and a tone one with Parallel/series switch. They couldn't work any better, and I consider myself hard to please. I never like anything.
I've had it worst installing other push/pulls in the past, but these DiMarzio were a walk in the park. Although I admit that bigger soldering points would be more confortable.
I will always recommend these pots.
They have nothing to envy CTS or others.
I used two on my guitar, a master vol with phase shifting and a tone one with Parallel/series switch. They couldn't work any better, and I consider myself hard to please. I never like anything.
I've had it worst installing other push/pulls in the past, but these DiMarzio were a walk in the park. Although I admit that bigger soldering points would be more confortable.
I will always recommend these pots.
They have nothing to envy CTS or others.
0
0
Report
B
Nice Feel
I used this pot for the "push pull" feature. I was able to split my humbuckers to single coil when the knob was pulled out. It worked great. A really nice feel of torque to it when turning the shaft, and firm soft but solid push and pull action. Very durable. NOTE 500k for humbuckers 250k for single coils.
5
0
Report
P
Nothing to complain about
These potentiometer aren't abundant, and this is my first one, so i won't compare it to anything. I haven't done the something either, so I don't know if the design is any bad. What I can say for sure, that this thing works perfectly. Sturdy, no cracking or additional noise. I'm using it for about 4 years and nothing has changed, even though our kids like to fiddling with it as well. If you need a switchable potentiometer, don't look any further.
0
0
Report
AS
Do their job
It's a nice pot. Sounds well wherever I tried it.
It can be a little brittle, though. Be careful when installing.
Also, be aware that the Asia made guitars have smaller holes in them. If you want this pot installed, you must enlarge the hole. Pencil and sandpaper do magic, though (be careful not to chip off finish pieces and use some thin sandpaper; I wouldn't start with anything less than 250).
It can be a little brittle, though. Be careful when installing.
Also, be aware that the Asia made guitars have smaller holes in them. If you want this pot installed, you must enlarge the hole. Pencil and sandpaper do magic, though (be careful not to chip off finish pieces and use some thin sandpaper; I wouldn't start with anything less than 250).
0
0
Report
D
Does the job!
Bought this to coil split a replacement Dimarzio humbucker (which came with several wiring schemes for split / out of phase etc). Went for the series/parallel option. The switching is noiseless and the volume pot shaft is reasonably stiff - better than my old pot which used to vary on its own.
1
0
Report
j
spotless
It does exactly what it was supposed to. It has a really quality feel to it.
0
0
Report
h
Really smooth action
I'm using it as a single/double coil push pull switch on my explorer.
Pros:
Rugged, have had no issues so far. Turning and switching is smooth as butter.
Cons
None
Pros:
Rugged, have had no issues so far. Turning and switching is smooth as butter.
Cons
None
0
0
Report
A
Brilliant
I'm really happy with this pot. The taper is nice and steady and has a comfortable torque. Push/pull feels solid and I've had no problems with it.
Be aware that if your guitar currently has import pots you'll probably have to enlarge the holes a little. Easily done with a tapered reamer.
Be aware that if your guitar currently has import pots you'll probably have to enlarge the holes a little. Easily done with a tapered reamer.
0
0
Report
m
Great quality in every aspect!
Even though it was quite hard soldering on such a small format pot, the result is rewarding. Great control, beautiful tone, combined with DiMarzio pickups (Titan set), clicky push-pull switch and feels sturdy.
0
0
Report