A
Very useful, high quality, low profile Y-split patch
I was after a low profile stereo Y-insert in order to take a single stereo TRS output from a guitar pedal and feed it into L-R 2x mono inputs on another pedal.
This does the job exactly as intended, and the flat cable makes it low profile - both at plug for compactness and for cable management! I'm also able to fit two plugs next to each other (e.g. stereo outs on a TC Electronic pedal), which I wasn't able to do with pancake plugs due to their width.
Very pleased - and can also therefore recommend other EBS patch cables for their quality and low profile, not just this Y-insert.
NB - also works in reverse, ie. splitting a single stereo TRS output into 2x mono. Seems obvious, but I've seen similar questions elsewhere so thought I'd note it here!
This does the job exactly as intended, and the flat cable makes it low profile - both at plug for compactness and for cable management! I'm also able to fit two plugs next to each other (e.g. stereo outs on a TC Electronic pedal), which I wasn't able to do with pancake plugs due to their width.
Very pleased - and can also therefore recommend other EBS patch cables for their quality and low profile, not just this Y-insert.
NB - also works in reverse, ie. splitting a single stereo TRS output into 2x mono. Seems obvious, but I've seen similar questions elsewhere so thought I'd note it here!
5
0
Report
TS
Good choice
The quality is not very good due to the thin cables, without it I stretch it a lot as if the cable was torn a bit ... of course it is one of the few options in the trade and nevertheless it does its job well, it helps me connect to my stereo pedals at trs inputs or vice versa
0
0
Report
T
great stuff, the originals
These are perfect for pedal board builders.
Save space
No noise
Good plugs
Very Flexible
Well made
Only con I can think of, is that these are not designed to plug/unplug all the time. I have used over 36 of these and the 10,18 , 28cm versions and THEY NEVER FAILED ME.
Save space
No noise
Good plugs
Very Flexible
Well made
Only con I can think of, is that these are not designed to plug/unplug all the time. I have used over 36 of these and the 10,18 , 28cm versions and THEY NEVER FAILED ME.
1
0
Report
G
What i was searching for
It was the solution i was searching for for my flashback 2 delay pedal. I connected a harley benton tap switch with it and it works perfectly! Plus it is so long that i can place the tap tempo switch wherever i want on the pedalboard!
0
0
Report
Pa
Nothing negative to say about this product.
1
0
Report
LZ
A simple, quality cable from EBS
It does its job and does it well. The whole flat patch series from EBS has been pretty great and this is no exception. I use it for my keyboards - going from the left and right outputs into the stereo input of an effects unit. The additional labels 'tip' and 'ring' on the mono jacks are a welcome plus.
0
0
Report
n
Using it with an MXR M-300 as a stereo breakout cable.
Using this item with an MXR M-300 as a stereo breakout cable, sometimes going into another stereo effect unit, or after a Torpedo Live, going into an audio interface for stereo reverb. Works perfectly, super light on pedalboard real estate. Love the soft and flat cable, very easy to handle, much needed flexibility for crowded smaller pedalboards. Ordered two to have a backup, never needed the backup, no issues so far. Sound quality does not suffer from any noticeable degradation due to the cable, no detectable increase in noise either. Happy.
0
0
Report
T
Good quality, great sound, minimal space taken
There don't seem to be a lot of options out there for this specific type of cable so I went with this one to be used with my MXR M300 Reverb pedal for return into stereo effects loop of the DSM & Humboldt Simplifier. As I use it on my pedalboard, it is great that it takes up minimal space between pedals.
One small advice for noobs like myself - the two ends don't have LEFT and RIGHT labels, but TIP and RING. "R" (RING) is for the RIGHT side ;)
One small advice for noobs like myself - the two ends don't have LEFT and RIGHT labels, but TIP and RING. "R" (RING) is for the RIGHT side ;)
2
0
Report
k
Great option for TRS stereo sockets
I bought this to use with a Dunlop TS-1 stereo pan tremolo. It has stereo out via two TS sockets, but Stereo in is one socket requiring a TRS cable. In my pedal chain the tremolo comes after a TC Flashback with stereo out, and wanting the stereo effect to continue I need a solution. This cable was my solution of choice. The flat cables and angles plugs are perfect for pedalboard use and I have not noticed any effect on tone nor any additional noise. A simple, affordable good solution!
0
0
Report
M
Foot pedal cable
I am using this cable to split the signal from my guitar pedalboard to connect to an extension foot pedal.
The cable is usually set up and I haven't had to remove it since I placed it. Therefore I cannot really comment on how it works if it's constantly unplugged and plugged again.
For me the cable does the job and with the very small connectors I can keep space on my pedal board for more gear. Great!
The cable is usually set up and I haven't had to remove it since I placed it. Therefore I cannot really comment on how it works if it's constantly unplugged and plugged again.
For me the cable does the job and with the very small connectors I can keep space on my pedal board for more gear. Great!
0
0
Report
