d
I <3 Roadworx
Hello,
I was looking for a stand that allowed me to do all kinds of configurations with speakers and laptop and supported the weight of my equipment with confidence. Luckily I found Roadworx.
The TM-X Arm 385 is handy. I use it with TM-X laptop holder to gain mobility, move to left or right, in and out. It is attached to the pole 470 clamp which also holds Genelec 8020DRW speakers with TM-X Arm 65 and TM-X VESA mounts.
With this Roadworx setup I make any adjustment for long working sessions at the desk. The laptop does not slip, it is well fixed. I can also orient the speakers in multiple positions.
I was considering other alternatives but after some time with the equipment I would choose Roadworx again.
Regards
I was looking for a stand that allowed me to do all kinds of configurations with speakers and laptop and supported the weight of my equipment with confidence. Luckily I found Roadworx.
The TM-X Arm 385 is handy. I use it with TM-X laptop holder to gain mobility, move to left or right, in and out. It is attached to the pole 470 clamp which also holds Genelec 8020DRW speakers with TM-X Arm 65 and TM-X VESA mounts.
With this Roadworx setup I make any adjustment for long working sessions at the desk. The laptop does not slip, it is well fixed. I can also orient the speakers in multiple positions.
I was considering other alternatives but after some time with the equipment I would choose Roadworx again.
Regards
0
0
Report
E
Good one
Note that the construction is quite tall. The lower screw handle goes quite low and the platform sits high. But it is tilts to any angle, so it's usable.
I mounted it on "TM-X Arm 385" to the lowest position and tilted around 30 degrees. Now the lowest front end of the platform is around 9 cm from the table, and the highest back end is around 22 cm from the table.
Between the lower screw handle and the table there is 5 cm of clearance.
I mounted it on "TM-X Arm 385" to the lowest position and tilted around 30 degrees. Now the lowest front end of the platform is around 9 cm from the table, and the highest back end is around 22 cm from the table.
Between the lower screw handle and the table there is 5 cm of clearance.
0
0
Report