A
Gets the job done
I really don't have any complains, other than that I would have liked if the "blackout"-button were bigger and stood out from the rest (making it easer to find and push while DJ'ing). Also the included USB-LED's "hood" weren't attached, but that was easily taken care of.
I'm still not sure how allot of the built in features work, but making scenes and chases is really easy. So is setting the microphones sensibility during Music-mode.
Overall; I'm pleased with it. I'll probably exchange it for a PC software based system sometime down the road, but up until then - it gets the job done.
I'm still not sure how allot of the built in features work, but making scenes and chases is really easy. So is setting the microphones sensibility during Music-mode.
Overall; I'm pleased with it. I'll probably exchange it for a PC software based system sometime down the road, but up until then - it gets the job done.
1
0
Report
S
My first DMX board
This was my first DMX board, and once I got used to it, I find it good.
The manual has some errors, and some descriptions are a little unclear, so getting started was a bit slow.
The manual has some errors, and some descriptions are a little unclear, so getting started was a bit slow.
2
0
Report
B
Simple controller
Need some gear to be able for light control when quick setup is needed. Of course there are limitation but for small gigs is enough as for me.
Overall construction on a good level, faders and dial controls is a kind of must-have. Good stuff for it's money.
Overall construction on a good level, faders and dial controls is a kind of must-have. Good stuff for it's money.
0
0
Report
A
Great features on a low end desk
Good desk with solid built chassis. Lots of features but the manual is quite difficult to read. One thing to bear in mind is that the desk has 16 fixture buttons and the the DMX addresses are set automatically.
Fixture 1 = DMX1 to 16
Fixture 2= DMX17 to 24 etc..
So if you want your lights on individual fixture buttons then you need to set the address on the lights accordingly.
Fixture 1 = DMX1 to 16
Fixture 2= DMX17 to 24 etc..
So if you want your lights on individual fixture buttons then you need to set the address on the lights accordingly.
0
0
Report
M
ok
ok to use with moving heads, the effector it's really complicated I have tried to use it but I could not I always forget how to set it, i have sold it and bought Dmx master 1
0
1
Report
