D
Cheap and cheerful
These are actually made by K&M (Konig and Meyer) - sadly they are nothing like as good as K&M microphone and speaker stands. I found them rather rigid and difficult to get the mic in and out. I didn't like them and I ended up giving them away. As a professional sound engineer, I would recommend AKG SA60 for slimline mics and BeyerDynamic MKV8 for tapered mics. They're a lot dearer but worth it.
0
0
Report
A
Tight Fit
This was supplied as a package with the Line6 TX35 Handheld and Line6 Rx: V35 receiver. However it's a very, very tight fit and the hardness of the plastic scratches my brand new microphone as during a typical performance it gets put in and out around 20 times. I had to buy a separate wider, softer mic holder. Maybe it would loosen over time but can't risk it. This holder should not be provided with this sized mic.
0
0
Report
b
large is large
good for the price. large is very large! not v flexible
0
0
Report
J
Not sure about the 5/8-27 to 3/8 BSW thread adaptor
The clip is okay, a little chunky in its appearance. My only gripe is the plastic thread adaptor that comes with it. I swapped it for a metal one straight away.
0
0
Report
z
cheap quality
This microhpone holder is just for backup and emergency use. Feel so plastic, I think it won't last long if you use it regularly.
0
0
Report