I
Not for flute
With good intentions, but not fit for purpose.
Pros:
None
Cons:
Handling noise
Expensive
Velcro supplied better replaced with a velcro cable-tie
Doesn't fit flute well
Velcro is far too long for flute and not "sticky" the whole length - so requires fitting skewed with a tail sticking out to ensure the rubber bit of the mount sits against the body of the flute (or else the whole mount just slides round).
I tried with a velcro cable-tie and this worked better (velcro both sides the whole length)
The show stopper however is the amount of handling and key noise when you're actually trying to use it.
Also....nearly £17 for a small rubber mount and a bit of velcro is really poor value.
Pros:
None
Cons:
Handling noise
Expensive
Velcro supplied better replaced with a velcro cable-tie
Doesn't fit flute well
Velcro is far too long for flute and not "sticky" the whole length - so requires fitting skewed with a tail sticking out to ensure the rubber bit of the mount sits against the body of the flute (or else the whole mount just slides round).
I tried with a velcro cable-tie and this worked better (velcro both sides the whole length)
The show stopper however is the amount of handling and key noise when you're actually trying to use it.
Also....nearly £17 for a small rubber mount and a bit of velcro is really poor value.
2
0
Report
A
Does not really work in practice
I bought this to amplify my flute live, using it to mount the t.bone CC100 microphone
Pros - none
Cons - lots...
It does not really work in practice.
The fixing tape is too long for a flute; I had to cut it.
The clip does not stay in place as it is too smooth - it just rotates round the body of the flute.
Wherever you install it the microphone and cable get in the way of the mouth piece.
The clip does not have any shock isolation, it picks up so much key noise from the flute which is clearly audible above the notes.
Very bad design.
Pros - none
Cons - lots...
It does not really work in practice.
The fixing tape is too long for a flute; I had to cut it.
The clip does not stay in place as it is too smooth - it just rotates round the body of the flute.
Wherever you install it the microphone and cable get in the way of the mouth piece.
The clip does not have any shock isolation, it picks up so much key noise from the flute which is clearly audible above the notes.
Very bad design.
0
0
Report
f
clip too long for flute, doesn't hold properly and no shock absorption, pretty much useless!
0
0
Report