A
Does the job
It's a good panel, it fits perfectly to the rack and takes the connectors very well too. A couple of niggles though ( and they are just niggles), there is a very slight flex in the panel when connecting stuff, mostly the middle sockets and it is very slight but there all the same, so not too sure how that will hold up over time. The other is depending on your ocd levels, it doesn't bother me but l did notice it , is that the two fixing holes for the screws are fractionally and l do mean factionally out so the sockets are pulling clockwise by a hair when fixed. Personally for the price l think this is a great panel and if the flexing doesn't become an issue six months down the line l'll happily come back and upgrade to five stars.
0
0
Report
JC
Great construction
Brilliant build quality, just a little annoying it doesn't come with any screws as they don't come with any of the adapter fittings either. Make sure to get these as well!
0
0
Report
M
Good, sturdy panel
Thon is good company, producing nicely priced gear of good quality.
This panel makes no exception from this rule.
I removed one star, because the screw holes are drilled slightly off the axis. That makes all sockets slightly "skewed" (not perpendicular to the panel). And that hurts visually.
They go more / / / / than | | | |.
(that was graphical representation of my above sentence)
Other than that - very good, robust product.
This panel makes no exception from this rule.
I removed one star, because the screw holes are drilled slightly off the axis. That makes all sockets slightly "skewed" (not perpendicular to the panel). And that hurts visually.
They go more / / / / than | | | |.
(that was graphical representation of my above sentence)
Other than that - very good, robust product.
0
0
Report
F
Practical but a little negative on the estetics
Rack panel does what you expect but in my case putting the Neutric XLR males and females in, noticed that the squares form of the XLR's can not be set completely vertical.as the pre-drilled holes in the panel for the screws are a little out of position
0
0
Report
t
Good quality but the M3 holes are slightly off angle
Good quality metal with edge folds for rigidity. Assembled some custom rack panels with these and Neutrik connectors but found that the M3 holes in this panel were slightly rotated from the angle required to get the connector square to the edge - the same on 3 of these panels. Also the D25 is slightly low to the bottom fold to get a nut spinner in there for tightening the nut, which risks deforming the hex slot in an M3 hex countersunk bolt.
0
0
Report