ST
Shielding tape
Used this on our TE30, just enough to do a Tele, when my son pluged it in, he couldn't hear any hum coming from the guitar over the soft hum from the amp (an old fender pro 1000),
1
0
Report
H
bon produit, mais un peu trop cher
Le produit est bon et la colle est conductive. J'aurais personnellement préféré une largeure plus grande. Par contre le prix est un peu trop élevé selon moi.
0
0
Report
MY
Not a lot, but it does the job
I redid the notoriously bad factory shielding job on an Ibanez Mikro bass - I needed a bit ore than one roll. There isn't a whole lot in a package, even if you don't have to cover a whole pickguard. Regardless, the adhesive works, the tape sticks and conducts and bends as it should, and working with it was quite easy.
0
0
Report
R
Good but length is not enough
5 for the quality
4 for the quantity. It needs 2 full pieces to shield all Les Paul's cavities up. Tip for DIY: to avoid multiple ground loops isolate guitar's potentiometers and jack cover's ground from shielding.
4 for the quantity. It needs 2 full pieces to shield all Les Paul's cavities up. Tip for DIY: to avoid multiple ground loops isolate guitar's potentiometers and jack cover's ground from shielding.
0
0
Report
H
Good enough
The low quantity will have you really salvaging the scraps to patch small gaps etc, but it's easy to use and exactly as advertised.
0
0
Report
K
Werkt goed, maar is wat klein
Eletronica van mijn gitaar is nu perfect gegrond door deze aanpassing, alleen om mijn stratocaster te gronden had ik net voldoende met 1 strip. Had er gelukkig twee gekocht dus geen problemen daar.
0
0
Report
p
Good but not enough
As others have stated, 1 piece is not enough. For full strat shielding you will need approximately 1,5 of this length, so get two pieces for one guitar.
The foil itself is thick enough and does a good job of shielding. I used it for a strat and I get no interference noise with single coils.
The adhesiveness is not very strong and it may peel off on the edges if you are not careful enough. I'd prefer it to be more "sticky".
The foil itself is thick enough and does a good job of shielding. I used it for a strat and I get no interference noise with single coils.
The adhesiveness is not very strong and it may peel off on the edges if you are not careful enough. I'd prefer it to be more "sticky".
0
0
Report