OK
Good concept let down by poor quality control and information
The USP of the Rockboard is that you can fit mod panels, right? Well good news - the Warwick team painted the inside of the screw threads that accept the mod boards so you can't actually screw anything in there without cross threading. I had to use a tap and die set to cut the paint out and then it was fine.
The board flexes under pressure, so if you're say pushing hard on a wah that has a switch under it, the top of the board will bend down slightly.
Oh and don't buy the Rockboard XLR cables that say they'll fit in the holes/slats - I assume they were measured to fit in an unpainted board, but when you try they actually scrape the paint off.
The board flexes under pressure, so if you're say pushing hard on a wah that has a switch under it, the top of the board will bend down slightly.
Oh and don't buy the Rockboard XLR cables that say they'll fit in the holes/slats - I assume they were measured to fit in an unpainted board, but when you try they actually scrape the paint off.
0
0
Report